French Bulldog bandana size: 15–22 in square

How do I measure a French Bulldog?

1. Stand the dog square. Use a soft tape where a flat collar sits, on the skin, not over the coat.
2. Snug the tape, then leave room for two fingers. That reading is the neck.
3. Add about 8 inches on the long edge for the knot. Pick the smallest square that covers it.
4. Fold corner to corner. The point rests on the chest, and the knot sits at the side or the back.

What fit notes matter for a French Bulldog?

Cut a 15 in square to a 22 in square for a typical adult French Bulldog neck of 13–18 inches where a flat collar sits. The build to expect is a short, thick neck with little length between head and shoulders. That interval is a fitting range for adult pets, not a breed-standard measurement and not a reason to skip the tape on the dog in front of you.

A 13 in neck uses the extra small 15 in square (long edge about 21.2 in). An 18 in neck uses the medium 22 in square (long edge about 31.1 in). One French Bulldog does not give you the size of the next.

The miss that shows up on a French Bulldog is a long tie that has nowhere to go except the water bowl. Look at the long edge, not at how wide the chest is. Weight, a photo, or the size printed on another dog's bandana does not give you the long edge.

Fold the square once, corner to corner, and tie the long edge so the point rests on the chest. Two fingers should still slide under the knot. If the point drags or the knot pinches, remeasure and recut instead of pulling the fabric tighter.

Measure where a flat collar sits and leave room for two fingers, as in common dog-apparel measuring guidance from theAmerican Kennel Club. Then use this site'ssquare chartrather than a clothing size label.