Large dog bandana size: 22–30 in square

How do I measure the neck?

1. Stand the dog square. Use a soft tape where a flat collar sits, on the skin, not over the coat.
2. Snug the tape, then leave room for two fingers. That reading is the neck.
3. Add about 8 inches on the long edge for the knot. Pick the smallest square that covers it.
4. Fold corner to corner. The point rests on the chest, and the knot sits at the side or the back.

What fit notes matter here?

A large-dog neck of 20–30 inches spans the medium 22 in square (long edge about 31.1 in) to the extra large 30 in square (long edge about 42.4 in). A Great Dane can sit at the top of that range. A lean sighthound at the same shoulder height can sit a size down. The tape is the difference.

The extra-large square is 30 inches, with a long edge of about 42.4 inches. Past about 34.4 inches of neck, that square cannot tie. Cut a custom square instead of pulling a smaller one closed.

Shop labels that only say large are not interchangeable. Read the side of the square or the long edge in inches. If the listing does not give a measurement, it is not a size.

Measure where a flat collar sits and leave room for two fingers, as in common dog-apparel measuring guidance from theAmerican Kennel Club. Then use this site'ssquare chartrather than a clothing size label.