Yorkshire Terrier bandana size: 15 in square

How do I measure a Yorkshire Terrier?

1. Stand the dog square. Use a soft tape where a flat collar sits, on the skin, not over the coat.
2. Snug the tape, then leave room for two fingers. That reading is the neck.
3. Add about 8 inches on the long edge for the knot. Pick the smallest square that covers it.
4. Fold corner to corner. The point rests on the chest, and the knot sits at the side or the back.

What fit notes matter for a Yorkshire Terrier?

Cut a 15 in square for a typical adult Yorkshire Terrier neck of 8–11 inches where a flat collar sits. The build to expect is a small neck hidden by a long coat. That interval is a fitting range for adult pets, not a breed-standard measurement and not a reason to skip the tape on the dog in front of you.

Both ends of that range use the extra small 15 in square (long edge about 21.2 in). The 8 extra inches on the long edge are there for the knot, not for a looser guess.

The miss that shows up on a Yorkshire Terrier is measuring over the coat and cutting a square the fur cannot fill. Part the hair and put the tape on the skin where a collar would sit. Weight, a photo, or the size printed on another dog's bandana does not give you the long edge.

Fold the square once, corner to corner, and tie the long edge so the point rests on the chest. Two fingers should still slide under the knot. If the point drags or the knot pinches, remeasure and recut instead of pulling the fabric tighter.

Measure where a flat collar sits and leave room for two fingers, as in common dog-apparel measuring guidance from theAmerican Kennel Club. Then use this site'ssquare chartrather than a clothing size label.